Yaa Features Of Apartment Bed Fusing Press Motorcar

Features of Flat Bed Fusing Press Machine

Muhammad Ibrahim Khalilullah
Department of Textile Engineering
Daffodil International University
Email: ibrahim23-3123@diu.edu.bd

Flat bed fusing press:
In this machine, at that spot are 2 beds; 1 bed is fixed called ‘BUCK’ as well as the other is moveable called ‘HEAD’. The interlining as well as garment ingredient are positioned showtime as well as placed on the BUCK. Due to switch operation, the HEAD moves downward as well as comes inward contact to BUCK as well as creates pressure level on the ingredient (interlining). Temperature is applied through HEAD as well as subsequently a for certain fourth dimension the HEAD moves upward.

Flat bed fusing press

Heating scheme may live on electrical or steam. Application temperature, pressure level as well as fourth dimension could live on pre-set inward this machine; thus fusing conditions are maintained properly. There are or as well as so modern apartment bed fusing machines likewise available where for 1 HEAD iii BUCKs are used. As a lawsuit production per unit of measurement fourth dimension increases. There is an air suction scheme alongside BUCK past times human foot operated switch, which helps faster production. Most of these machines are fitted alongside timers as well as programmed controls as well as tin give the axe plow over high levels of fusing quality.

Features:

1. This type of machine contains 2 components. these equally (a) Head as well as (b) Buck.
2. The caput is boundary loaded as well as movable as well as buck remains fixed.
3. Buck is covered alongside soft mat which is prepared alongside fabric, blanket or silicon rubber.
4. Both surface of buck as well as caput is covered alongside PTFE.
5. Head is heated alongside electrical flow or steam.
6. Sometimes heating organization is joined alongside buck.

Working regulation of Flat Bed Fusing Press:

1. At showtime the business office of the garment to live on fused as well as spread over flately on the buck as well as the resin coated interlining is placed on it correctly.
2. The caput is gradually lowered on the buck past times switch as well as the required pressure level is applied as well as heating is done uniformly on the surface of the buck.
3. Head is separated from the buck subsequently applying estrus as well as pressure level till predermined time.
4. Then the suction bedchamber sucks air from the buck.
5. After sucking the air, the interlining becomes mutual depression temperature as well as fuses inward the fabrics permanently.

Advantages:

• Temperature, pressure level as well as fusing fourth dimension is adjustable.
• Easier procedure as well as around normally used.
• Low cost.
• Tends to cut down textile shrinkage.

Disadvantage:

• Not suitable for large scale production.
• Needs checking of fusing status subsequently for certain period. 

You tin give the axe likewise read:
Working Principle of Continuous Fusing Machine 

 

Share this post