Yaa Reckoner Controlled Require Knife Cutting Machine

Computer Controlled Straight Knife Cutting Machine

Rahat Khan
Dept. of Apparel Manufacturing
Atish Dipankar University of Science as well as Technology
Cell: +8801717781833
Email: rahat.info@gmail.com

Introduction:
In this machine, cutting knife effort is controlled past times a computer. Cutting tabular array used for calculator controlled straight knife cutting machine is dissimilar from normal cutting table. The tabular array top is covered amongst a bed of nylon bristle. The nylon bristle bed is capable to back upwardly the stuff lay as well as too allows the conduct knife to buy the farm through as well as motion to a greater extent than or less the nylon bristle. Hence cutting of each as well as every ply of stuff inwards the lay is confirmed. The nylon bristle bed too allows air suction through the bed to brand the lay compressed past times vacuum pressure.

Computer Controlled Straight Knife Cutting Machine

On the cutting tabular array at that spot are 2 rails on 2 sides, running length administration of the cutting table. Influenza A virus subtype H5N1 cross beam moves length administration of the cutting table, situated on the rails. The cutting caput is situated on the cross beam as well as moves on the cross beam but the effort is inwards width administration of the cutting table. The cutting knife is situated within the cutting head. Due to the combined effort of the cross beam, cutting head, as well as cutting knife, stuff cutting is done at whatever line, angle, as well as indicate rattling accurately. The combined effort is controlled past times 3 servo motors.

When fabric cutting command is given through computer, the cutting knife starts lay cutting from a reference indicate starting inwards the calculator retentiveness of the marker. Notch indicate is made past times the same cutting knife. Drill grade is too produced past times a carve upwardly drill situated inwards the cutting head. Speed of cutting depends on lay height. For example, for a compressed lay of 7.5 cm height, cutting speed volition last 7.5 meter per minute. As the cutting proceeds, the vacuum line per unit of measurement area may driblet into the lay. To avoid the reduced vacuum line per unit of measurement area problem, some other polythene canvas curl may last used to encompass the cutting division of the lay. Computerized conduct knife cutting machine does non require whatever purpose of marker. In some cases, marking may last used to position the cutting components.

Advantages: