Now You Know Measurement of Fabric Strength by Ball Bursting Test Method
Thursday, 17 May 2018
Edit
Measurement of Fabric Strength by Ball Bursting Test Method
Md. Nure Alam
Teaching assistant at Dept. of textile
Daffodil International University
Dhaka, Bangladesh
Email: nure23-4238@diu.edu.bd
Md. Nure Alam
Teaching assistant at Dept. of textile
Daffodil International University
Dhaka, Bangladesh
Email: nure23-4238@diu.edu.bd
Bursting strength:
This tear strength is basically used for knitted, lace, non-woven fabric, parachute fabrics, filters, sacks and nets etc. It is the uniformly distributed force over a given area applied to the fabric surface which is needed to break.
There are mainly two types of bursting strength test-
- Hydraulic or Diaphragm burst
- Ball burst
- This method is used to determine the force required to rupture textile fabric by forcing a steel ball through the fabric.
- Fabrics having more extension that cannot be checked by diaphragm bursting strength test.
- This test can be carried out on a standard universal strength tester with a suitable attachment.
- This method used for knitted fabric, non-woven fabric, coated fabric etc.
- Using a circular template 12.5 cm in diameter, mark and cut out ten samples of the fabric from random areas so as to be representative of the entire sample.
- No sample shall be taken nearer than 20 cm from the edge of the roll.
According to US Standard:
- Steel ball having diameter 1 inch (25.4 mm) with a clamp of diameter 1.75 in (44.45 mm).
- Speed of ball = 12 in/min (305mm/min).
- Steel ball is an attachment which is used in the tensile mode on a standard tensile strength testing machine.
- There are not a British Standard for the ball bursting strength of knitted fabrics, although a standard does exist for coated fabrics.
- Steel ball having diameter 25.2 mm with a clamp of diameter 45 mm.
- Speed of ball = 5 mm/sec
Fig: Bursting strength test |
- Test is carried out using an attachment on standard tensile testing machine.
- Place the sample in the ring clamp as flat as possible with no wrinkles or tension and tighten the clamp.
- In the test, the steel ball is pushed through the stretched fabric and the force required to do so is recorded.
- By the steel ball downward force apply at constant rate until the sample break.
- Ball bursting follow the CRE method.
Fig: Ball bursting machine |
- Sample size should be cut properly by template.
- Sample keep ring clamp as flat as possible without no wrinkle.
- Sample should be tighten properly by the clamp.
By this article we can learn about the way of testing the strength of fabric by the ball bursting method. We can also learn about the machine used into this method and to know about the working description.